Roland FP-7F Implementation Manual page 21

● 0120: Phaser
This is a stereo phaser. A phase-shifted sound is added to the original sound
and modulated.
No Parameter Value
1 Mode 0-2
2 Manual #2 0-127
3 Rate Mode 0-1
4 Rate #1 1-127
5 Rate 0-21
6 Depth 0-127
7 Polarity 0-1
8 Resonance 0-127
9 Cross Feedback 0-98
10 Mix 0-127
11 Low Gain 0-30
12 High Gain 0-30
13 Level 0-127
● 0129: Multi Stage Phaser
Extremely high settings of the phase difference produce a deep phaser effect.
No Parameter Value
1 Mode 0.5
2 Manual #2 0-127
3 Rate Mode 0-1
4 Rate #1 1-127
5 Rate 0-21
6 Depth 0-127
7 Resonance 0-127
8 Mix 0-127
9 Pan 0-127
10 Low Gain 0-30
11 High Gain 0-30
12 Level 0-127
● 012a: Infinite Phaser
A phaser that continues raising/lowering the frequency at which the sound is
modulated.
No Parameter Value
1 Mode 0-3
Description
4-Stage,
8-Stage, Number of stages in the phaser
12-Stage
Adjusts the basic frequency from
0-127 which the sound will be
modulated.
When this is set to "note," the
Hz, note effect is synchronized with the
tempo.
0.05-10.00 Hz Frequency of modulation (Hz)
note Frequency of modulation (note)
0-127 Depth of modulation
Selects whether the left and right
phase of the modulation will be the
same or the opposite.
Inverse: The left and right phase
Inverse, will be opposite. When using a
Synchro mono source, this spreads the
sound.
Synchro: The left and right phase
will be the same. Select this when
inputting a stereo source.
0-127 Amount of feedback
Adjusts the proportion of the
phaser sound that is fed back into
-98 - +98% the effect.
Negative (-) settings will invert the
phase.
0-127 Level of the phase-shifted sound
-15 - +15 dB Gain of the low range
-15 - +15 dB Gain of the high range
0-127 Output Level
Description
4-Stage,
8-Stage,
12-Stage,
Number of phaser stages
16-Stage,
20-Stage,
24-Stage
Adjusts the basic frequency from
0-127 which the sound will be
modulated.
When this is set to "note," the
Hz, note effect is synchronized with the
tempo.
0.05-10.00 Hz Frequency of modulation (Hz)
note Frequency of modulation (note)
0-127 Depth of modulation
0-127 Amount of feedback
0-127 Level of the phase-shifted sound
L64 - 63R Stereo location of the output sound
-15 - +15 dB Gain of the low range
-15 - +15 dB Gain of the high range
0-127 Output Level
Description
Higher values will produce a
1, 2, 3, 4 deeper
phaser effect.
2 Speed #1 0-127
3 Resonance #2 0-127
4 Mix 0-127
5 Pan 0-127
6 Low Gain 0-30
7 High Gain 0-30
8 Level 0-127
● 0123: Stereo Flanger
This is a stereo flanger. (The LFO has the same phase for left and right.) It
produces a metallic resonance that rises and falls like a jet airplane taking off or
landing. A filter is provided so that you can adjust the timbre of the flanged
sound.
No Parameter Value
1 Filter Type 0-2
2 Cutoff Freq 0-16
3 Pre Delay 0-125
4 Rate Mode 0-1
5 Rate #1 1-127
6 Rate 0-21
7 Depth #2 0-127
8 Phase 0-90
9 Feedback 0-98
10 Low Gain 0-30
11 High Gain 0-30
12 Balance 0-100
13 Level 0-127
21
Speed at which to raise or lower
the frequency at which the sound
-100 - +100
is modulated (+: upward / -:
downward)
0-127 Amount of feedback
0-127 Volume of the phase-shifted sound
L64 - 63R Panning of the output sound
Amount of boost/cut for the
-15 - +15 dB
low-frequency range
Amount of boost/cut for the
-15 - +15 dB
high-frequency range
0-127 Output volume
Description
Type of filter
Off: No filter is used
Lpf: Cuts the frequency range
Off, Lpf, Hpf
above the Cutoff Freq
Hpf: Cuts the frequency range
below the Cutoff Freq
200-8000 Hz Basic frequency of the filter
Adjusts the delay time from when
0.0-100.0 ms the direct sound begins until the
flanger sound is heard.
When this is set to "note," the
Hz, note effect is synchronized with the
tempo.
0.05-10.00 Hz Frequency of modulation (Hz)
note Frequency of modulation (note)
0-127 Depth of modulation
0-180 deg Spatial spread of the sound
Adjusts the proportion of the
flanger sound that is fed back into
-98 - +98% the effect.
Negative (-) settings will invert the
phase.
-15 - +15 dB Gain of the low range
-15 - +15 dB Gain of the high range
Volume balance between the direct
D100:0W -
sound (D) and the flanger sound
D0:100W
(W)
0-127 Output Level