Alarm Mode Displaying The Alarm Time; Alarm With Signal Tone - Roberts R9969 Manual

Alarm mode
Displaying the alarm time
1. Press the appropriate Alarm button (signal tone or radio). The last
setting will be displayed or the radio symbol will flash.
Note: The display will return to the current time after 7 seconds.

Alarm with signal tone

1. With the radio switched off, press the Alarm button (signal tone).
The last alarm set flashes.
2. Enter the alarm time using the numerical buttons '1...0'.
3. Press the Freq./Clock button to confirm the entry. The alarm time
entered stays lit.
The receiver switches on with the signal tone at the set time (alarm
duration 1 hour). The signal tone increases in volume for one minute,
stops for a minute and starts again.
4. Press the On/Off Stop button to switch off the alarm.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
1
1
2
3
19