(2) Installing to the table
Plain
washer
Spring
washer
Hexagonal nat
(3) Adjusting the belt (when M-91 is used)
1
Approx. 15mm / 9.8N
–2–
1) Install the control box to the table with the fitting
bolt(asm.)suppliedwiththeunitasaccessories.
At this time, insert the nut and washer supplied
with the unit as accessories as shown in the
figure so that the control box is securely fixed.
2) Setthemachineheadtothetableafterinstalling
thecontrolbox(orwithsmall-sizedmotor)tothe
table.(RefertoInstructionManualforthesewing
machine.)
) Adjust the belt tension by turning upper and
lower nuts 1 of the adjustment bolt and adjust
theheightofthecenterofthemotorsothatthe
belt sags 5 mm (9.8N) when the center of the
beltispressedbyhand.
When the belt tension is excessively low,
medium or low speed rotation becomes
uneven, or stop accuracy is deteriorated.
When the tension is excessively high,
deterioration of the motor is advanced.
So, be careful.