JUKI IP-110 Instruction Manual page 9

(2) Entering a password
<Password entry popup screen>
1) Input the eght-dgt password "449593" wth Numerc nput swtches 3 . Confirm the input num-
ber wth Enter swtch 4 .
Then, nput the eght-dgt password agan wth Numerc nput swtches 3 and re-confirm the input
number wth Enter swtch 4 .
* If Cancel swtch 5 is pressed during the password entry, the data being input will be cleared.
It is also possible to return the setting for the production support function to the disable.
The password to disable the production support function is "59634649."
2) When the password entry has been completed properly, the switch display ▶ (A in the figure) ad-
ditionally appears on the sewing management information screen No. 1. The sewing management
information screen No. 2 can be displayed by pressing Sewng management nformaton screen No.
2 display changeover switch 6 .
If you have input a wrong password, the setting fault alert will sound and the switch will not addition-
ally appear on the screen.
<Sewing management information screen No. 1 (maintainer level)>
* If the password input secondly is different from that entered firstly, the password mismatch popup
screen wll appear. In ths case, nput the correct password.
<Password mismatch popup screen>
Numeric input switch 3
Numeric input switch 3
Sewing management information screen No. 2 display changeover switch 6
Cancel switch 5
Enter switch 4
A
–  –