JUKI APW-896/IP-420 Instruction Manual page 70

No.
Stacker timer 3
Motion time of material sweeping bar is set.
＊ It is possible to set only when
used.
Stacker timer 4
Time to advance timing to release the sewing product by lifting clamp
foot is set.
When clampng a short sewng product, the amount to drop by tare s
adjusted.
＊ It is possible to set only when
used.
Sewing speed under the high-speed mode
Number of revolutions of lockstitch section is set.
＊ It is possible to set only when
selecton s set to memory swtch.
Sewing speed under the low-speed mode
Number of revolutions of condensation and back tack sewing sections
s set.
＊ It is limited by
＊ It is possible to set only when
selecton s set to memory swtch.
Soft start, first stitch
Number of revolutions of first stitch at sewing start is limited.
Soft start, second stitch
Number of revolutions of second stitch at sewing start is limited.
Soft start, third stitch
Number of revolutions of third stitch at sewing start is limited.
Return speed of clamp foot
Return speed of clamp foot is set.
Thread breakage detection
Wth/wthout thread breakage detecton s selected.
Flap presser motion mode
Motion order of flap presser is selected.
＊ When right and left are simultaneously actuated with customizing of
pedal setting, this parameter is neglected and the right and left are
smultaneously actuated.
. . . Item that is not displayed due to other setting state.
Item
clamp bar stacker opton s
clamp bar stacker opton s
sewng speed settng
sewing speed under the high-speed mode.
sewng speed settng
Wth thread
breakage detecton
From rght
Right/Left at the
same tme
− 66 −
Setting range
/
Edit unit
0.00 to
9.99
/
0.01 sec.
0.00 to
9.99
/
0.01 sec.
1000 to
3000
/
100
st/mn
1000 to
2500
/
100
st/mn
500 to
2500
/
100
st/mn
500 to
2500
/
100
st/mn
500 to
2500
/
100
st/mn
3 to 9
/
1
- - -
Wthout thread
breakage detecton
From left
Side where flap is
put
Initial value
0.70 sec.
0.00 sec.
2500st/mn
1500st/mn
500st/mn
700st/mn
1000st/mn
7