Sdm Templates And Switch Stacks - Cisco Catalyst 3120 Software Manual

Chapter 8 Configuring SDM Templates
Table 8-2
Resource
Unicast MAC addresses
IPv4 IGMP groups and multicast routes
Total IPv4 unicast routes:
•
•
IPv6 multicast groups
Directly connected IPv6 addresses
Indirect IPv6 unicast routes
IPv4 policy-based routing ACEs
IPv4 or MAC QoS ACEs (total)
IPv4 or MAC security ACEs (total)
IPv6 security ACEs

SDM Templates and Switch Stacks

All stack members must use the same SDM desktop template that is stored on the stack master. When a
new switch is added to a stack, the SDM configuration that is stored on the stack master overrides the
template configured on an individual switch. For more information about stacking, see
"Managing Switch Stacks."
You can use the show switch privileged EXEC command to see if any stack members are in SDM
mismatch mode. This example shows the output from the show switch privileged EXEC command when
an SDM mismatch exists:
Switch# show switch
Switch#
------------------------------------------------------------
*2
4
This is an example of a syslog message notifying the stack master that a stack member is in SDM
mismatch mode:
2d23h:%STACKMGR-6-SWITCH_ADDED_SDM:Switch 2 has been ADDED to the stack (SDM_MISMATCH)
2d23h:%SDM-6-MISMATCH_ADVISE:
2d23h:%SDM-6-MISMATCH_ADVISE:
2d23h:%SDM-6-MISMATCH_ADVISE:System (#2) is incompatible with the SDM
2d23h:%SDM-6-MISMATCH_ADVISE:template currently running on the stack and
2d23h:%SDM-6-MISMATCH_ADVISE:will not function unless the stack is
2d23h:%SDM-6-MISMATCH_ADVISE:downgraded.
2d23h:%SDM-6-MISMATCH_ADVISE:will downgrade the stack to use a smaller
OL-12247-01
Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates
Directly connected IPv4 hosts
Indirect IPv4 routes
Role Mac Address
Master 000a.fdfd.0100
Member 0003.fd63.9c00
IPv4-and-IPv6
Default
2 K
1 K
3 K
2 K
1 K
1 K
2 K
1 K
0
0.5 K
1 K
0.5 K
Current
Priority State
5 Ready
5 SDM Mismatch
Issuing the following commands
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Understanding the SDM Templates
IPv4-and-IPv6 IPv4-and-IPv6
Routing VLAN
1.5 K 8 K
1 K 1 K for IGMP
groups
0 for multicast
routes
2.75 K 0
1.5 K 0
1.25 K 0
1 K 1 K
1.5 K 0
1.25 K 0
0.25 K 0
0.5 K 0.5 K
0.5 K 1 K
0.5 K 0.5 K
Chapter 5,
8-3