Cisco Catalyst 3120 Software Manual page 849

Chapter 38 Configuring IP Unicast Routing
Table 38-5
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
1
NSF
NSF capability
Router ID
Summary address
OL-12247-01
Default OSPF Configuration
awareness
Default Setting
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mb/s.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
2
Enabled . Allows Layer 3 switches to continue forwarding
packets from a neighboring NSF-capable router during hardware
or software changes.
Disabled.
Note The switch stack supports OSPF NSF-capable routing
for IPv4.
No OSPF routing process defined.
Disabled.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Configuring OSPF
38-27