Cisco Catalyst 3120 Software Manual page 844

Configuring RIP
Command
Step 4 network network number
Step 5 neighbor ip-address
Step 6
offset list [access-list number | name]
{in | out} offset [type number]
Step 7
timers basic update invalid holddown
flush
Step 8
version {1 | 2}
Step 9 no auto summary
Step 10
no validate-update-source
Step 11 output-delay delay
Step 12 end
Step 13
show ip protocols
Step 14
copy running-config startup-config
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
38-22
Purpose
Associate a network with a RIP routing process. You can specify multiple
network commands. RIP routing updates are sent and received through
interfaces only on these networks.
You must configure a network number for the RIP commands to
Note
take effect.
(Optional) Define a neighboring router with which to exchange routing
information. This step allows routing updates from RIP (normally a
broadcast protocol) to reach nonbroadcast networks.
(Optional) Apply an offset list to routing metrics to increase incoming
and outgoing metrics to routes learned through RIP. You can limit the
offset list with an access list or an interface.
(Optional) Adjust routing protocol timers. Valid ranges for all timers are
0 to 4294967295 seconds.
update—The time between sending routing updates. The default is
•
30 seconds.
invalid—The timer after which a route is declared invalid. The
•
default is 180 seconds.
• holddown—The time before a route is removed from the routing
table. The default is 180 seconds.
flush—The amount of time for which routing updates are postponed.
•
The default is 240 seconds.
(Optional) Configure the switch to receive and send only RIP Version 1
or RIP Version 2 packets. By default, the switch receives Version 1 and 2
but sends only Version 1.
You can also use the interface commands ip rip {send | receive} version
1 | 2 | 1 2} to control what versions are used for sending and receiving on
interfaces.
(Optional) Disable automatic summarization. By default, the switch
summarizes subprefixes when crossing classful network boundaries.
Disable summarization (RIP Version 2 only) to advertise subnet and host
routing information to classful network boundaries.
(Optional) Disable validation of the source IP address of incoming RIP
routing updates. By default, the switch validates the source IP address of
incoming RIP routing updates and discards the update if the source
address is not valid. Under normal circumstances, disabling this feature
is not recommended. However, if you have a router that is off-network
and you want to receive its updates, you can use this command.
(Optional) Add interpacket delay for RIP updates sent.
By default, packets in a multiple-packet RIP update have no delay added
between packets. If you are sending packets to a lower-speed device, you
can add an interpacket delay in the range of 8 to 50 milliseconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 38 Configuring IP Unicast Routing
OL-12247-01