Cisco Catalyst 3120 Software Manual page 925

Chapter 39 Configuring IPv6 Unicast Routing
Passive Interfaces
As with EIGRP IPv4, EIGRP IPv6 allows you to specify your EIGRP IPv4 interfaces and to select a
subset of those to be passive interfaces. Use the passive-interface default command to make all
interfaces passive, then use the no passive-interface command on selected interfaces to make them
active. EIGRP IPv6 does not need to be configured on a passive interface.
EIGRP IPv6 Commands
Table 39-1
Table 39-1 EIGRP IPv6 Interface Commands for EIGRP IPv6
Command
ipv6 eigrp as-number
ipv6 authentication key-chain eigrp 1 name
ipv6 authentication mode eigrp as-number md5
ipv6 bandwidth-percent eigrp as-number percent
ipv6 hello-interval eigrp as-number seconds
ipv6 hold-time eigrp as-number seconds
ipv6 next-hop-self eigrp as-number
ipv6 split-horizon eigrp as-number
ipv6 summary-address eigrp as-number ipv6-prefix
[admin-distance]
For more complete syntax and usage information on these commands, see the Cisco IOS command
references.
Table 39-2
Table 39-2 EIGRP IPv6 Router-mode Commands
Command
ipv6 router eigrp as-number
default-metric bandwidth delay reliability loading mtu Sets metrics for EIGRP IPv6.
distance internal-distance external-distance
distribute-list prefix-list list-name
log-neighbor-changes
log-neighbor-warnings seconds
maximum-paths number-paths
OL-12247-01
shows the supported interface commands for EIGRP IPv6 on the switch.
Purpose
Enables EIGRP IPv6 on a specified interface.
Enables authentication of EIGRP IPv6 packets.
Specifies the type of authentication used in EIGRP IPv6 packets.
Configures the percentage of bandwidth that may be used by EIGRP
IPv6 on an interface.
Configures the hello interval for the EIGRP IPv6 routing process
designated by an autonomous system number.
Configures the hold time for a particular EIGRP IPv6 routing process
designated by the autonomous system number.
Informs the EIGRP IPv6 router that the IPv6 next hop is itself.
Enables EIGRP IPv6 split horizon.
Configures a summary aggregate address for a specified interface.
shows the supported router configuration commands for EIGRP IPv6 on the switch.
Purpose
Specifies the EIGRP IPv6 routing process to be configured.
Allows the use of the best route to a node—either the internal or
external distance.
Applies a prefix list to EIGRP IPv6 routing updates that are received
or sent on an interface.
Enables the logging of changes in EIGRP IPv6 neighbor
adjacencies.
Enables the logging of EIGRP neighbor warning messages.
Controls the maximum number of equal-cost routes that is
supported by a routing process for EIGRP IPv6.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Understanding IPv6
39-7