Cabling And Powering Up The Enclosure; Cabling The Enclosure; Onboard Administrator Cabling - HP BladeSystem c7000 Setup And Installation Manual

Cabling and powering up the enclosure

Cabling the enclosure

After all system hardware is installed, cable the components. See the HP ProLiant BladeSystem c-Class Site
Planning Guide on the Documentation CD or the HP website (http://www.hp.com) for additional cabling
and site planning requirements.
WARNING:
sure that all power is completely disconnected at the source before beginning any power
connections to the power bus bars or power bus box.
WARNING:
power components.
To cable the system:
Connect the Onboard Administrator modules.
1.
Connect the network cables to the interconnect modules. See the documentation that ships with the
2.
interconnect modules, or the HP ProLiant BladeSystem c-Class Site Planning Guide on the
Documentation CD or the HP website (http://www.hp.com/go/bizsupport).
Connect to the AC or DC power source in your facility and power up the enclosure
3.
enclosure" on page 59).

Onboard Administrator cabling

To reduce the risk of electric shock or injury due to high-current electrical energy, be
Be sure that all circuit breakers are locked in the off position before connecting any
("Powering up the
Cabling and powering up the enclosure 56