Installation; Installation Overview; Disassembling The Enclosure - HP BladeSystem c7000 Setup And Installation Manual

Installation

Installation overview

To set up and install the enclosure:
Disassemble the enclosure
1.
For rack-free installations
2.
surface, then install the rear cage and enclosure components.
For rack installations, install the enclosure into the rack
3.
26) then reassemble the enclosure.
Install the enclosure components
4.
Connect the enclosure components
5.
enclosure.
Connect the AC power cables and power up the enclosure
6.
Configure the enclosure
7.
Display.

Disassembling the enclosure

Before installing the enclosure into the rack, you must disassemble the enclosure. Because a fully-populated
enclosure can weigh up to 217.7 kg (480 lb), remove the components and the rear cage from the enclosure
to make moving and installing the enclosure easier. Two people should work together to remove the rear
cage from the enclosure.
The empty enclosure with the rear cage installed weighs 58.6 kg (129 lb). When the enclosure is
disassembled, the empty enclosure without the rear cage installed weighs 35.5 kg (78 lb). The empty rear
cage weighs 23.2 kg (51 lb).
("Disassembling the enclosure" on page 21).
("Rack-free installation" on page 24), set up the enclosure on an appropriate
("Component installation" on page 29) into the enclosure.
("Cabling and powering up the
("Running the Insight Display installation
("Installing the enclosure into the
enclosure" on page 56) in the
("Powering up the enclosure" on page 59).
steps" on page 65) using the Insight
rack" on page
Installation 21