Removing The Software - HP -UX 11i v3 Administrator's Manual

1. Verify that the product was installed by issuing the following command:
# swlist -l product | grep -i HP-APA
Output similar to the following displays:
HP-APA-FMT
HP-APA-KRN
HP-APA-LM
HP-APA-NETMOD
HP-APA-RUN
If the sub-products are not displayed, reinstall the software. See
(page 18)
2. Verify that the software is configured in the kernel by issuing the following command:
# what /stand/vmunix | egrep -i hp_apa
Output similar to the following displays:
If nothing is displayed, rebuild the kernel.

Removing the software

If you need to remove the HP APA software, complete the following steps:
1. To remove the software from the system, enter the following command:
swremove
2. Highlight the HP APA software:
J4240AA
3. Choose Mark for Remove from the Actions menu.
4. Choose Remove from the Actions menu to begin product removal and to display the Remove
Analysis window.
5. Click OK in the Remove Analysis window when the Status field displays a Ready message.
6. Click YES at the Confirmation window to confirm that you want to remove the software.
The swremove command unloads the fileset, runs the control scripts for the filesets, and
builds the kernel. The estimated time for processing is 3 to 5 minutes depending on the
complexity of your system. When the status field indicates Ready, a Note window opens.
Click OK on the Note window to reboot the system.
NOTE:
the kernel.
See swremove(1M) for more information.
B.11.31.20
B.11.31.20
B.11.31.20
B.11.31.20
B.11.31.20
for more information.
$Revision: hp_apa: HP Auto-Port Aggregation (APA): B.11.31.20 Aug 20 2008 11:30
You must reboot the system after the software removal to deconfigure HP APA in
HP Auto-Port Aggregation APA formatter product.
HP Auto-Port Aggregation kernel products.
HP Auto-Port Aggregation LM commands.
HP Auto-Port Aggregation nwmgr/NCweb libraries.
HP Auto-Port Aggregation APA command products.
"Installing the software"
Removing the software 19