HP -UX 11i v3 Administrator's Manual page 118

2. Configure HP APA. Do the following:
a. Unplug all LAN connections to be aggregated.
b. Create the aggregations. They must be either 2 or 4 port trunks. For two-port
aggregations, the beginning port number must be odd. For four-port aggregations, the
beginning port number must be a number divisible by 4 plus 1 (for example, 1, 5, 9, 13).
Use the following command to create a four-port aggregation:
HP9304(config)#trunk server e 1/5 to 1/8
c. Save the configuration. Enter:
HP9304(config)#write mem
d. Reboot the switch. Enter the following:
HP9304(config)#exit
HP9304#reload
e. After switch reboots, plug in the cables and display the trunk configuration as follows:
HP9304>show trunk
Information similar to the following displays:
Configured trunks:
Trunk Type
3
5
17
19
20
21
Operational trunks:
Trunk Type
3
5
17
19
20
21
To remove the trunk in the previous example, enter the following:
no trunk server e 1/5 to 1/8
118 Switch configuration information
Ports
Server 1/5 1/6 1/7 1/8
Server 1/9 1/10 1/11 1/12
Server 2/1 2/2
Server 2/5 2/6
Server 2/7 2/8
Server 2/9 2/10
Ports
Server 1/5 1/6 1/7 1/8
Server 1/9 1/10 1/11 1/12
Server 2/1 2/2
Server 2/5 2/6
Server 2/7 2/8
Server 2/9 2/10
Duplex Speed Tag Priority
Full 100M No level0
Full 100M No level0
Full 100M No level0
Full 100M No level0
Full 100M No level0