B-1 Sample Lanconfig.ascii Configuration File - HP -UX 11i v3 Administrator's Manual

Example B-1 Sample lanconfig.ascii Configuration File
#***********************************************
#******* LAN MONITOR CONFIGURATION FILE
#*** For complete details about the parameters and how
#*** to set them, consult the lanqueryconf(1m) manpage
#*** or your manual.
#*** All timeout values are microseconds; they are rounded up
#*** or down appropriately.
#***********************************************************
#***********************************************
# The valid range for POLLING_INTERVAL: 500,000-10,000,000 usec
# Default value for POLLING_INTERVAL: 10,000,000 usec
# Minimum value for DEAD_COUNT: 2
# Default value for DEAD_COUNT: 3
#**********************************************
POLLING_INTERVAL
DEAD_COUNT
#***********************************************
# By default, LM_RAPID_ARP is on.
# If LM_RAPID_ARP is on, the valid ranges are:
# LM_RAPID_ARP_INTERVAL: 1000000-4000000 (default:1000000 usec
# LM_RAPID_ARP_COUNT:
# (LM_RAPID_ARP_INTERVAL * LM_RAPID_ARP_COUNT) <= 60s
#**********************************************
LM_RAPID_ARP
LM_RAPID_ARP_INTERVAL
LM_RAPID_ARP_COUNT
# ****************************************************************
#
#
# In Proactive Failover, the active port of a fail-over group
# is the port with the minimum normalized port cost. This means **
# a fail-over group will change its active port to a ready port **
# having a lower normalized port cost, even when the current
# active port remains up. You must use cost-based fail-over
# groups in order to get the Proactive Failover behavior.
#
# To define a cost-based fail-over group, all the ports in the
# fail-over group must have a cost defined. Cost has a valid
# range of between 1 and 100, inclusive. The value must be
# preceded by a colon (:) character.
#
# If one of the ports in a fail-over group does not have a cost **
# defined, the fail-over group is invalid.
#
# If all ports in a fail-over group have no cost defined, the
# default failover behavior is used. The available port with
# the highest priority becomes the active port.
#
# By default, the lanqueryconf -s command creates only
# priority-based fail-over groups.
#
# Example with cost defined:
# FAILOVER_GROUP
# STATIONARY_IP
# # Pri/Stdby
# PRIMARY
# STANDBY
#
# For more information on how to use proactive fail-over, see
# the HP Auto Port Aggregation Administrator's Guide at
# http://docs.hp.com.
# ****************************************************************
10000000
3
5 - 60
off
1000000
10
Note:
lan903
195.55.55.55
I/f Pri Cost
lan900 7 : 1
lan901 6 : 2
(default is 10)
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
**
lanconfig.ascii file 93