Valve Tray Replacement - Regency LIBERTY L900E-NG Owners & Installation Manual

1) Remove the exterior brick panels.
2) Remove the glass door.
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
Latch Location
Latch
b. Swing the door out from the top and release
the hinges on the left and right side of the
door by lifting them up.
Door
c. Place the door on a soft surface to prevent
scratching.
Regency ® L900E Direct Vent Gas Fireplace

VALVE TRAY REPLACEMENT

3) Loosen the screw that holds the right side
heat shield in place.
Heat
Shield
4) Lift up and pull out the heat shield slightly
to clear the screwheads and then hang it
on the top bracket (located directly above
the heat shield).
5) Disconnect both sources of power; the
power cord, located on the left hand side of
the fi rebox and the wires connected to the
back-up battery located on the right side of
the fi rebox.
Hinge
6) Remove the log set.
7) Remove the interior brick panels.
MAINTENANCE
8) Remove the grate by undoing the 2 screws
on the right and left side.
Grate
9) Remove the front burner by removing the
screw.
Backup
Battery
Power
Receptacle
Front Burner Removed
10) Remove the back burner by removing the
screw.
Front Burner
Back Burner
39