Back-Up Battery Installation - Regency LIBERTY L900E-NG Owners & Installation Manual

Liberty l900e series gas fireplace
Table of Contents

Advertisement

1) Unsecure the battery from the outer fi rebox base fl ange by cutting the
cable tie and remove from protective wrapping.
2) Remove the plastic pin protectors from the battery.
3) Loosen the screw that holds the right side heat shield in place.
4) Lift the heat shield up and pull out slightly to clear the head screws
and then hang it on the top bracket (located directly above the heat
shield, close to the top of the fi rebox).
5) Pull out the battery wires from the right side of the fi rebox.
Regency
®
L900E Direct Vent Gas Fireplace

BACK-UP BATTERY INSTALLATION

Heat
Shield
Battery
Wires
6) Connect the red and black wires to the battery accordingly.
7) Place the battery into position on the velcro at the base of the fi rebox
as shown.
8) Re-install the heat shield.
INSTALLATION
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liberty l900e-lp

Table of Contents