Quadra-Fire QF130 Owner's Manual page 34

LOG SUPPORT
PILOT
BRACKET
OUTER TINES
Figure 5.
Log #1 (SRV2225-701): Position the groove on the log with the right grate tine as shown in Figure 6. The opposite end of
the log will rest on the log support. Rotate the opposite end of the log clockwise until it contacts the refractory panel.
LOG CONTACTS
LEFT REFRACTORY
PANEL
MATE SLOT WITH
GRATE TINE
Figure 7. Place Log #2
Log #2 (SRV2225-703): Mate the grate tine with the slot on the bottom of Log #2. The back end of the log rests on the log
support. The side of the log will contact the left refractory as shown in Figure 7.
POSITION LOG
ON FLAT SPOT
3
LOG CONTACTS LEFT
REFRACTORY PANEL
LOG RESTS ON
LOG SUPPORT
Figure 9. Place Log #3
Log #3 (SRV2225-702): Position the left end of the log on the fl at spot of Log #2 as shown in Figure 7 and Figure 9. The
right end of the log rests on the log support and touches the back refractory. The left end of the log should contact the left
refractory panel.
Log #4 SRV(2225-705): Mate the slot on the bottom of Log #4 with the right log pin. Refer to Figure 11 for location of log
slot. Rotate the right end of the log clockwise until the groove on the end of the log mates with the grate bar.
34
LOG PINS
ANDIRONS
FLAT SPOTS
FOR LOG #6 AND LOG #3
2
FLAT SPOT
FOR LOG #7
LOG CONTACTS
BACK REFRAC-
TORY PANEL
Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11
LOG RESTS ON
LOG SUPPORT
Figure 6. Location of Log #1
SLOT
Figure 8. Slot on Log #2
MATE LOG
PIN WITH
LOG SLOT
MATE GRATE BAR
WITH LOG GROOVE
Figure 10. Place Log #4
LOG GROOVE
CONTACTS
1
GRATE TINE
4