Entrapment Protection - Genie GCL-MJ&MH Manual

ENTRAPMENT PROTECTION

The GCL-MJ&MH™ can be used with the following UL Approved entrapment devices in compliance with UL325 requirements active starting August 29, 2010.
UNTIL ONE OF THESE MONITORED EXTERNAL ENTRAPMENT DEVICES IS INSTALLED, THE OPERATOR WILL NOT ALLOW MOMENTARY CONTACT OPERATION IN THE CLOSE DIRECTION.
LISTED DEVICES
MillerEdge ME, MT and CPT series monitored edge sensors used in combination with
Timer-Close Module or OPAKMEIGX.S Interface Module.
Residential Safe-T-Beam® Monitored Photocells model OSTB-BX P/N 38176R.
Commercial Photoeye Kit P/N OPAKPE.S
NEMA4 Monitored Photocells P/N OPAKPEN4GX.S.
STEEL, NON-INSULATED
UL
Model HP
L is ted
16GA. 18GA.
197 246
GCL-MJ&MH 1/2 YES
Note: Total door weight and not square footage is the critical factor in selecting the proper operator. These Sq.Ft. measurements are based on square doors, e.g. 16' x 16'.
Unbalanced Fire Shutters have a maximum square footage of 52 for 22GA. steel and 42 for 20GA. steel.
Model HP UL L is ted
GCL-MJ
1/2
Y es
GCL-MH
T=Trolley S=Jackshaft,SideMount C=Jackshaft,CenterMount
Note: Total door weight, and not the square footage, is the critical factor in selecting the proper operator.
Square footage measurements are based on "square doors." (Example=16' x 16')
NOTE: Doors that require special windloading and wide doors, normally require increased strutting (reinforcement). Strutting doors can significantly increase door
weight beyond weight shown. Consult Customer Service for the impact of wind load andstrutting on square foot limits.
NOTE: "PU-FIP" stands for "polyurethane, foamed-in-place." If no notation is present, insulation is "polystyrene, layed-iin-place."
GCL-MJ&MH
Medium Duty Operator
Section 3: Critical Installation Information
Rolling Steel Door Chart (sq. ft.)
STEEL, INSULATED
20GA. 22GA. 24GA. 26GA. 18GA. 20GA.
246 338 394 394 148 148
Sectional Door Chart (sq. ft.)
CommercialSteelInsulated&Non-Insulated
Door S eries -> 216 216 ins. 220
Max. 16GA.
16GA. 20GA.
Door Flush
Mounting
Flush Ribbed
Type Weight Steel
Steel Steel
(Lbs) Insulated Insulated
TS 620 170 120 230
ALLOWABLE DOOR WIDTH
COUNTER DOOR GRILLES
22GA. ALUM. STL/SST ALUM. STL/SST
197 126 126
300
220 ins. 2415 2415 ins. 2411 2411 ins.
20GA. 24GA. Nominal Nominal
24GA.
Ribbed Ribbed 24GA. 24GA.
Ribbed
Steel Steel Ribbed Ribbed Steel
Steel
Insulated Steel Insulated
160 270 200 300 256
www.geniecompany.com
ANY WIDTH
30 FEET
30 FEET
35 FEET
FIRESTAR 2" SLAT FIRESTAR 3" SLAT
20GA. 22GA. 16GA. 18GA.
N/A
200 N/A N/A N/A
Thermospan Thermomark
125 150 200 200-20 5150
PU/FIP PU/FIP
Insulated Insulated
PU/FIP PU/FIP PU/FIP
2" Raised
Insulated Insulated Insulated
20GA. Panel
1.38" 2"
Exterior 1.38"
256 256 240 160 256
08-12
FIRESTAR 3" SLAT
SHEET DOOR
INSULATED
20GA. 22GA. 26GA
20GA. 22GA. .
N/A
N/A N/A N/A 256
Aluminum
5200 451 452
PU/FIP
Insulated 1/4" or 1/2"
1/8" Glass
Raised Glass
1.38"
Panel 1.38"
2"
256 210 144
3.2