Fujitsu SPARC Enterprise M8000 Service Manual page 375
Oracle
Hide thumbs
Also See for SPARC Enterprise M8000:
- Product notes (88 pages) ,
- Overview manual (80 pages) ,
- Getting started manual (4 pages)
Table of Contents
Advertisement
5. Remove the DDC to be replaced.
a. Using a Phillips screwdriver, turn the knob screw securing the bottom eject/lock
lever 90 to 180 degrees to unlock the lever. (Turn the knob screw while lightly
pulling the lever with one hand.)
b. Unlock the eject/lock levers to pull the DDC off the backplane.
c. While grasping the eject/lock levers, pull out the DDC slowly from the slot.
Removing the DDC (Front of the M8000)
FIGURE 19-3
6. Place the removed DDC on an antistatic mat.
2
1
Chapter 19
DDC Replacement
19-5
Advertisement
Table of Contents
Troubleshooting
