Fujitsu SPARC Enterprise M8000 Service Manual page 294

Note – When the PCI cassette is removed from the IOU, the tab raises the front of the card
from the card connector.
a. Move the PCI card in the direction of the arrow, and mount it on the PCI cassette
FIGURE 13-7
b. Push the PCI card until the notched part on the base plate of the PCI card
Note – When fixing the PCI card in position after aligning it with the card positioning tab,
do so while pulling the lever about 2 cm from the frame.
13-12 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
by inserting the part projecting out at the bottom of the bracket of the PCI card
into the hole at the bottom of the front panel of the PCI cassette and inserting the
pin of the PCI cassette into the notched part at the top of the bracket of the PCI
card.
Mounting the PCI Card
touches the card-positioning tab from the PCI cassette.