Reload Global Timer Events - Fujitsu MS-6191 User Manual

Mainboard MS-6191
Suspend Type
Select the Suspend Type. The settings are: PWRON Suspend, Stop Grant.
Standby Mode
When enabled and after the set time of system inactivity, all devices except will be shut off. The settings are:
1/2/4/8/12/20/30/40 Min, 1 Hour, and Disabled.
HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive will be powered down while all other
devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15Min and Disabled.
HDD Down In Suspend
When enabled, the hard disk drive will be powered down with the other device during suspend mode.
The settings are: Enabled and Disabled.
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state. The settings are:
Delay 4 Sec, Instant-Off.
PWRON After PWR-Fail
The settings are power ON/OFF or Former-Sts. During power ON, after every AC/Power Loss, the system will be
turned on. During Former-Sts, after every AC/Power Loss, whatever the system status, it will be the same when the AC
power returns. During Off, after every AC/Power Loss, the system will be shutdown.
RI Resume/WOL
To use this function, you need a LAN add-on card which support power on functions. It should also support the wake-up on
LAN jumper (JWOL).
Enabled
Disabled
Modem Use IRQ
This determines the IRQ in which the MODEM can use. The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
RTC Resume
This function is for setting date and time for your computer to boot up. During Disabled, you cannot use this
function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
system will boot up. Set to 0, to boot
every day.
Time(hh:mm:ss) Alarm You can choose what hour, minute and
second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the operating system, before this

Reload Global Timer Events

Reload Global Timer events are I/O events whose occurrence can prevent the system from entering a power saving mode or
can awaken the system from such a mode. In effect, the system remains alert for anything which occurs to a device which is
configured as Enabled , even when the system is in a power down mode.
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Wake up on LAN supported.
Wake up on LAN not supported.
You can choose which month the
function will work.
50