Pnp/Pci Configurations - Fujitsu MS-6191 User Manual

Mainboard MS-6191

3.9 PnP/PCI Configurations

This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system which allows
I/O devices to operate at speeds nearing the speed the CPU itself uses when communicating with its own special components.
This section covers some very technical items and it is strongly recommended that only experienced users should make any
changes to the default settings.
PnP OS Installed
Reset Configuration Data
Resources Controlled By
IRQ Resources
DMA Resources
PCI/VGA Palette Snoop
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration Data (ESCD) when
you exit Setup if you have installed a new add-on and the system reconfiguration has caused such a serious conflict that the
operating system can not boot.
The settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and Plug and Play
compatible devices. However, this capability means absolutely nothing unless you are using a Plug and Play operating
system such as Windows 95/98. If you set this field to "manual" choose specific resources by going into each of the sub
menu that follows this field (a sub menu is preceded by a " "). The settings are: Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on the type of device using
the interrupt.
Memory Resources
This sub menu can let you control the memory resource.
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
CMOS Setup Utility - Copyright(C) 1984-1999 Award Software
PnP/PCI Configuration Setup
Yes
Disabled
Auto(ESD)
Press Enter
Press Enter
Disabled
Item Help
Menu Level >
52