Table of Contents
Advertisement
Remote controller
Display
1 MODE button
2 10 °C HEAT button
3 SET TEMP. button (
4 ECONOMY button
5 SLEEP button
6 FAN button
7 START/STOP button
8 SET button (Vertical)
9 SET button (Horizontal)
0 SWING button
A TIMER MODE button
B TIMER SET (
C CLOCK ADJUST button
D RESET button
E TEST RUN button
● This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air conditioner's
thermostat function to operate incorrectly.
● If this button is pressed during normal opera-
tion, the unit will switch to test operation mode,
and the Indoor Unit's OPERATION Indicator
Lamp and TIMER Indicator Lamp will begin to
fl ash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air conditioner.
F Signal Transmitter
/
)
/
) button
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
G Temperature SET Display
H Operating Mode Display
I SLEEP Display
J Transmit Indicator
K Fan Speed Display
L SWING Display
M T imer Mode Display
N Clock Display
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp fl ash when a remote controller but-
ton is pressed if the function is not available.
En-4
Advertisement
Table of Contents
