To Perform Ntsc Input Board Picture Quality Adjustment; To Set The Adjustment Mode [Ajyb Command]; To Exit The Adjustment Mode [Ajn Command] - Pioneer RM-V1000NU Technical Manual

*6 : Display of remote and manual states
REMOTE MODE
MANUAL MODE
*7 : Slot number
*8 : Type of input board
NTSC BOARD
V.SCAN BOARD
NO BOARD
*9 : NTSC input board state
STANDARD MODE
NO STANDARD MODE : When non-standard NTSC signal is input
*10: Display of VBS/ Y/C select switch state
VBS
Y/C
*11: Type of output board
4 OUT BOARD
NO BOARD

To Perform NTSC Input Board Picture Quality Adjustment

To Set the Adjustment Mode [AJYB command]

To Exit the Adjustment Mode [AJN command]

Input: AJYB
Explanation: AJYB command : Sets the NTSC input board to the adjustment mode.
AJN command
• When adjusting the NTSC input board, the adjustment command will be ignored if AJYB is not executed.
• To set the optional RGB board to the adjustment mode, use the :A command. (Refer to pages 121 and on-
wards.)
: Remote state
: Manual state
: NTSC input board
: Optional RGB input board
: No input board is incorporated
: When standard NTSC signal is input
: Composite video signal input (Indicates V FIL.ON for the V.SCAN BOARD)
: Y/C separation signal input (Indicates V FIL.OFF for the V.SCAN BOARD)
: 4 output board
: No output board is incorporated
, AJN
: Exists the adjustment mode.
APPENDIX (MVP manual)
117