Picture Frame Adjustment Procedure; Command Reference; To Shift To The Operation Mode [! Command]; To Set Different Screens For Adjusting Convergence [Dffb Command] - Pioneer RM-V1000NU Technical Manual

PICTURE FRAME ADJUSTMENT PROCEDURE

Adjust the MVP picture frame as follows.
(1) Connect the RS-232C cable to the MVP panel.
(Refer to (P.105) "Connection with MVP EXTERNAL COMPUTER".)
(2) Initialize the picture frame data in RAM.
ex. &L0
(3) Set to the magnified screen to be adjusted.
ex. M11B22
(4) Perform coarse adjustment of the picture frame.
ex. &P21
(5) Perform fine adjustment of the picture frame.
ex. &G0
(6) Repeat steps (4) and (5) for every position on the screen.
(7) Save the adjustment data in the EEPROM.
ex. &W1 (Refer to the &W command.)

COMMAND REFERENCE

To Shift to the Operation Mode [! command]

Input: !
Explanation: By executing this command when the power is on, various commands can be executed.

To Set Different Screens for Adjusting Convergence [DFFB command]

Input: DFFB
Explanation: • By executing this command, the NTSC input image will be displayed on a single 1x1 display.
• Use the crosshatch, etc. for NTSC input images.
• For details of the convergence adjustment, refer to the MPJ adjustment manual.
(To return the 4-screen magnified display)
• The NTSC input image will be 4-screen magnified displayed with the input of 9
(Refer to @ command (P.112))
(Refer to &L command.)
(Refer to the M command, @ command.)
(@9 )
++–– (Refer to the &P command.)
LLRU (Refer to the &G command.)
APPENDIX (MVP manual)
.
111