Replacing The Screen - Pioneer RM-V1000NU Technical Manual

Multi projection system
Table of Contents

Advertisement

7 Replacing the Screen

[1] Remove the panels at the top and right side of the screen unit to be replaced. (Remove 12 screws. )
The panels are made of polycarbonate. Adhesive double coated tapes are pasted to the frames. To remove
the panel, pull it out carefully in the horizontal direction as much as possible and it will not deform.
[2] Peel off the black vinyl tape at the edges. The top and right sides of the screen will become free. Remove the
screen by pulling in the top right direction. (fig. 5-10)
* The left side and bottom of the screen is fixed to the panel by adhesive double coated tape. The lenticular
sheet can be removed relatively easily. The fresnel lens is fixed firmly and will not come off by just pulling
in the top right direction. To remove, while pulling in the top right direction, remove it by opening it as if
opening a door. (Fig. 5-11)
Position according
to this part
(Fig. 5-10)
[3] Re-paste the adhesive double coated tape on the panel. It can be peeled off easily by scratching it with your
finger backwards. Then paste a new adhesive double coated tape according to the figure.
(Fig. 5-12)
OPERATIONS • MAINTENANCE
(Fig. 5-11)
97

Advertisement

Table of Contents
loading

Table of Contents