To Perform Coarse Adjustments Of The Picture Frame [&P2, &Q2 Commands] - Pioneer RM-V1000NU Technical Manual

To Perform Coarse Adjustments of the Picture Frame [&P2, &Q2 commands]
Input: &P2d h h
2 1
Explanation: &P2 command: Horizontal direction
&Q2 command: Vertical direction
h h
1
Although the data is an absolute value, the relative value with the current data can also be speci-
fied.
• Input: &P2d
&Q2d
&P2d
***
+–+–
&P2d
***
RES
&P2d
***
100
• The screen start position is the position of the screen actually displayed in respect to the magni-
fied image.
Position displayed on the screen
• This command is used for the coarse adjustment of the picture frame when the adjustment range
is exceeded with the &G command.
• The data shift amount is greater than the &G command.
• Execute &W0
• Note: For details of the picture frame adjustment procedure, refer to ''Picture Frame Adjustment Procedure".
• Note: To end the adjustment, be sure to input
If is not input, commands input thereafter may not be executed.
• Note: If the power is cut in this state, the new screen start position data will not be saved. To save the data,
execute &W1
h , &Q2d h h h
2 3 2 1 2 3
d : Screen position (1 to 2)
2
h : crew start position data (&P2:000 to 1C5, &Q2:000 to 20A)
2 3
+ , &P2d –
2 2
+ , &Q2d
2 2
d : Screen position (1 to 2)
2
+ : Left direction (horizontal), and up direction (vertical) looking at the screen.
– : Right direction (horizontal), and down direction (vertical) looking at the screen.
: Adjustment mode end
2
: Input the current value at ***
2
: RES is the initial value
2
: Input the value after checking the current value
to initialize. (Refer to &W command.)
. (Refer to the &W command.)
–
Magnified image
.
APPENDIX (MVP manual)
113