Weider PRO 575 User Manual page 11

18.
Press two 38mm Square Inner Caps (44) into the
ends of the Seat Frame (17).
Orient the Seat (37) with the wide end on the side
shown. Attach the Seat (37) to the Seat Frame
(17) with four M6 x 16ram Bolts (72).
19. Lubricate an M10 x 154mm Bolt (69). Attach the
Seat Frame (17) to the Backrest Frame (16) with
the Bolt, two M10 Washers (79), and an M10
Nylon Locknut (77). Do not overtlghten the
Nylon Locknut; the Seat Frame must be able
to pivot easily.
20. Attach the Right and Left Power Assist Legs (20,
21) to the Leg Lever (19) with two M10 x 100mm
Bolts (66) and two M10 Nylon Locknuts (77).
21. Refer to the CABLE DIAGRAMS on page 16 of
thls manual to Identlly the dlfferent cables
Included wlth the welght bench.
Locate the Bench Cable (58). Route the Cable
through the Front Leg (18) and attach it to the
Leg Lever (19) with an Mt0 x 9tmm Bolt (67),
two 35mm Spacers (82), two MIO Washers (79),
and an M10 Nylon Locknut (77).
Press a 2" x 3" Inner Cap (50) Into the bottom of
the Leg Lever (19).
18
19
2O
21
17
79
69
66
79
67
11