Weider PRO 575 User Manual page 10

14. Attach the Bench Frame (14) to the Back Leg
(39) with an M10 x 78mm Bolt (70), two M1O x
164mm Bolts (71), an M10 Washer (79), and
three M10 Nylon Locknuts (77). Do not tighten
the Nylon Locknuts yet.
15. Attach the Leg Lever Bumper (54) to the Front
Leg (18) with the M4 x 19mm Screw (68) and an
M5 Washer (92).
Press a 38.1mm x 76.2mm Inner Cap (49) and a
2 _ x 3" Inner Cap (50) Into the Leg Lever (19).
. Lubricate an M1O x 102mm Bolt (91). Attach the
Leg Lever (19) to the Front Leg (18) with the Bolt
and an MIO Nylon Locknut (77). Do not over-
tighten the Nylon Lock]nut; the Leg Lever must
be able to pivot easlty.
16. Press four 25.4mm x 38.1mm Inner Caps (45)
into the Backrest Frame (16).
Odant the Backrest (38) as shown. Attach the
Backrest to the Backrest Frame (16) with four M6
x 16mm Bolts (72).
17. Press two 38mm Square Inner Caps (44) into the
ends of the Support Leg (13).
Lubricate an M1O x 154mm Bolt (69). Attach the
Support Leg (13) to the Backrest Frame (16) with
the Bolt, two M10 Washers (79), and an MIO
Ny_n Locknut (77).
Lubricate an M1O x 164mm Bolt (71). Attach the
Support Leg (13) to the Back Leg (39) with the
Bolt, two M1O Weshers (79), and an M10 Nylon
Locknut (77).
Lubdcate two M1O x 45mm Bolts (76). Attach the
Backrest Frame (16) to the Sliding Seat Frame
(15) with the Bolts, two M10 Washers (79), and
two M10 Nylon Locknuts (77).
Do not overtighten the M1O Nylon Locknuts
(73'); the Support Leg (13) and the Backrest
Frame (16) must be able to pivot easily.
10
14
14
€
77
71
15
16
49
60 77
-Ioi
%1.1
92<
38
\
45
16
72
45-
17
77
76
89