Advertisement
mNSTALL THE GUmDE BAR
1.
Make sure the Chain Brake® bver is puibd back
into the DISENGAGED position (Fig. 17).
2.
Remove the bar retaining nut (B1) and the screw (B2)
at rear of clutch cover (C). Remove clutch cover (C)
by pulling straight
out, some force may be required.
(Fig. 18).
3.
Hace the slotted end of the guide bar over the bar
bolt (F). Slide guide bar behind dutch drum (G) until
the guide bar stops (Fig. 19).
Fig, 17
mNSTALL THE SAW CHAroN
WARNING: Always
use
protective gloves
when handling the saw chain.
J
1. Spread chain out in a
loop
with cutting edges (A)
pointing CLOCKWISE around loop (Fig. 20).
2. Slip the chain around the sprocket (B) behind the
dutch (C). Make sure the links fit between the
sprocket teeth (Fig. 21).
3.
Guide the drive links into the groove (D) and around
the end of the bar (Fig. 21).
NOTE: The saw chain may droop slightly on the lower
part of bar. This is normal.
4.
Pull guide bar forward until chain is snug. Ensure all
drive links are in the bar groove.
5.
Install the clutch cover. Make sure the chain does
not slip off of the bar. Install the bar retaining nut
hand tight and follow tension adjustment instructions
in the next section. Replace screw at rear of clutch
cover
NOTE: The guide bar retaining nut is installed only hand
tight at this point because saw chain adjustment
is required, Follow instructions in Saw Chain
Tension Adjustment.
Fig, 18
Fig, 19
B2
B1
Fig, 20
/
B
D
Fig, 21
14
Advertisement
