Advertisement
WARNING: Operate
this unit only
ina weft- ventilated
outdoorarea. Carbon monoxide exhaust
fumes can be bthaIina confined area.
WARNING" Never
operate thesaw
without thebarand
chainproperly i nstaibd.
STARTUNG UNSTRUCTUONS
1.
Mix gas with oil Fill fuei tank IA, Fig. 3) with fueVoii
mixture. See 0i/and
Fue! Mixing/nstructions_
2.
Fill the oii tank (B) with correct chain and bar oil (Fig. 3).
3.
Be certain the Chain Brake® is disengaged (C)
before starting unit (Fig. 3).
NOTE: see page 15 fig. 24.
4.
Press red STOP switch to the '1" ON position (Fig. 4).
5.
Pull the blue lever (D) out as far as it will go until the
blue lever stays out (Fig. 5). This advances the
throttle so you do not have to hold the trigger while
starting.
6.
Fully press and release the primer bulb (E) 10 times,
slowly. Some amount of fuel should be visible in the
STOPPmNG mNSTRUCTmONS
1_ Release the trigger and allow the engine to return to
the idle speed.
2.
Move the STOP switch to the STOP position.
NOTE: For emergency stopping, simply activate the
Chain Brake® and move the STOP switch down.
C
Fig, 3
7.
Place the saw on a firm flat surface. Hold saw firmly
as shown (Fig. 7).
8.
Pull the rope with a controlled and steady motion 4
times. Then move the blue lever (D)all the way in (Fig. 6).
NOTE: The unit uses Spring Assist Startinq
TM,
which
significantly reduces the effort requured to start the
engine. You must pull the starter rope out far
enough to hear the engine attempt to start. There
is no need to pull the rope briskly-- there is no
harsh resistance when pulling. Be aware that this
starting method is vastly different from (and much
easier than) what you may be used to.
9.
Hold saw firmly and pull rope until saw starts. This
could take 4 more pulls.
10. Let the saw warm up for 10 seconds. Depress and
release trigger (F) for idle (Fig. 7).
NOTE:
In some cases due to operating conditions
(altitude,temperature,
etc)your chain saw may
need a slight adjustment to the idle speed.
1. locate idle adjustment screw(G). (fig. 6)
2. if saw will not idb-tum
screw clockwise
1/4 to1/2
turn-saw should idle
3. If chain turns while idlingturn
screw
counterclockwise
until chain stops.
11. If engine fails to start, repeat these instructions.
NOTE: When starting a warm engine:
1. make sure switch is on
2. pull blue choke all the way out and then push it back
m-This advances the throttle so you do not have to
hold trigger during starting
3.
push primer10x or until you see fuel in the bulb
4.
pull rope until engine starts
5.
depress and release trigger for idle
Fig, 4
Fig, 5
Fig, 6
Fig. 7
G
E
10
Advertisement
