Assembly; Unpackpressure Washer; Attach Handle And Accessory Tray - Troy-Bilt 20344 Operator's Manual

Assembly
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with the
recommended fuel and oil.
If you haveany problems with the assembly of your
pressure washer, pleasecall the pressure washer helpline
at (888) 611-6788. If calling for assistance,pleasehavethe
model, revision,and serial number from the datatag available.
UnpackPressure Washer
1. Removethe parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensureyou have all included items prior to assembly.
Items in the carton include:
• Main Unit
• Handle
• CleaningTank
• High Pressure Hose
• Spray Gun
• NozzleExtension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Bottle
• Parts Bag (which includes the following):
• Safety Goggles
• Operator's Manual
• Engine Operator's Manual
• Owner's Registration Card
• Bag containing 4 Multi-Colored Spray Tips
• Spray Gun HolderWireform
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (4)
To prepare your pressurewasher for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected
to main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
J \
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. insert carriage bolts (D) through holes from back of
unit and attach a plastic knob (E) from front of unit.
Tighten by hand.
3. insert cleaning tank (F) into wireform (G) on handle (H)
and push down firmly until cleaning tank snaps into
place.
NOTE:Make sure detergent shut-off valve and detergent
siphoning tube is facing down when installing cleaning tank.
4. Place accessory tray (J) over holes (K) on handle
(viewing from front of unit). Push the tree clips (L) into
the holes until they sit fiat against the accessory tray.
3