Assembly; Unpack Pressure Washer; Attach Handle, Cleaning Tanks And Accessory Tray - Troy-Bilt 020489 Operator's Manual

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at
(888) 611-6708. If calling for assistance, please have the
model, revision, and serial number from the data tag
available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• Handle
• Cleaning Tanks Assembly
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Bottle
• Parts Bag (which includes the following):
• Safety Goggles
• Operator's Manual
• Owner's Registration Card
• Bag containing 4 Multi–Colored Spray Tips
• Spray Gun Holder Wireform
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (6)
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle, cleaning tanks and accessory tray to
main unit.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.
8
Attach Handle, Cleaning Tanks and Accessory
Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
C
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Place cleaning tanks (D) over holes (F) on handle
(viewing from rear of unit). Push tree clips (E) into top
holes until they sit flat against cleaning tanks.
3. Insert carriage bolts (G) through bottom holes of
cleaning tanks, the handle and handle supports from
rear of unit and attach a plastic knob (H) from front of
unit. Tighten by hand.
G
4. Place accessory tray (J) over holes (L) on handle
(viewing from front of unit). Push the tree clips (K) into
the holes until they sit flat against the accessory tray.
A
B
F
E
D
H
L
K
J
www.troybilt.com