Advertisement
Quick Links
Advertisement
Related Manuals for Troy-Bilt 020287
Summary of Contents for Troy-Bilt 020287
-
Page 8: Section 3: Assembly
Section 3: Assembly Attach Handle Add Engine Oil and Fuel Place handle assembly onto handle supports connected • Place pressure washer on a level surface. to main unit. Make sure holes in handle align with holes CAUTION on handle supports (Figure 2). Any attempt to crank or start the engine before it has Figure 2 —... -
Page 18: Troubleshooting
Section Troubleshooting TROUBLESHOOTING Problem Cause Correction Low pressure spray tip installed. Replace spray tip with high pressure spray tip. Water inlet is blocked. Clear inlet. Inadequate water supply. Provide adequate water flow. Inlet hose is kinked or leaking. Straighten inlet hose, patch leak. Pump has following problems: Clogged inlet hose strainer. -
Page 19: Limited Warranty
LIMITED WARRANTY “Troy-Bilt® is a registered trademark of MTD and is used under license to Briggs & Stratton Power Products. Briggs & Stratton Power Products will repair or replace, free of charge, any part, or parts of the equipment** that are defective in material or workmanship or both.Transportation charges on product submitted for repair or replacement under this warranty must be...