Optional/Additional Components; Adding Drives - Pioneer DRM-7000 Operating Instructions Manual

6.0

Optional/Additional Components

6.1

Adding Drives

Any drive designed for use in the DRM-7000 may be easily added to this system. The power
supply shipped with the unit is capable of supporting up to eight additional components. Install
the devices in to the lower rear bays (bay 1 through bay 8). To add drives or other components
to the remaining rear bays (bays 9 thought bay 16), install an additional power supply.
Touch a separate metallic surface to discharge static electricity before handling a power supply
or another component.
connections when installing into the Changer.
1. Install the drive unit(s)
No tools are required to install a drive. While drives may be installed in any of the rear bays
(bay 1 through bay 8), the connector board shipped with the Changer is configured for drives to
be installed into bay 1 and bay 2.
Avoid any contact between your body and the power supply
• Install an add-on connector board if
- 39 -
DRM-7000
Operating Instructions
necessary
• Specify the SCSI IDs and set the
termination switches on the back of
the drives before installing the units
• Verify that the drives are mounted on
the guide rails
• Listen for the clicking sound as the
drive is pushed into the bay
• Push the drive in until the lock lever
on the drive shifts to the locked
position