Products Provided With The Drm-7000 - Pioneer DRM-7000 Operating Instructions Manual

• Two drives installed on separate cables
• Both drives are connected to the internal daisy-chain board using the cables provided
(it is necessary to purchase another SCSI cable to connect the Changer to the HOST)
To install three or more drives or to use more than one SCSI bus (to increase data transfer
rates), it is necessary to purchase additional SCSI boards and cables.
The following factors are key in selecting the appropriate components for your system.
• Types and numbers of drives and the bays to be used
(installing nine or more drives requires installation of an additional power supply)
• Positions where SCSI boards will be installed
(the Changer is equipped with an internal daisy-chain board and a drive board)
• SCSI ID to be assigned to each drive
(a SCSI ID may not be assigned to two or more drives on the same bus)
• Cable layout between the various drives and the SCSI boards
(refer to the Installation chapter, Examples of SCSI Cable Connections)
• Which drives will be terminated
(which drive will be at the end of the SCSI chain thus has the termination switch turned
ON)
The DRM-7000 is shipped with a single power supply which provides enough power for up to
eight devices installed in the lower rear bays (bay 1 through bay 8). The maximum power
supplied to the eight bays is 5V/12A or 12V/8A with no more than 5V/4A or 12V/4A over any
single connector. Thus any device installed in these bays must be below that power level.
An additional power supply must be added in order to install up to eight devices in the upper
rear bays (bay 9 through bay 16). The maximum power consumption for the upper bays is
equal to that of the lower bays.
WARNING: Use Pioneer-approved add-on products only
2.7

Products Provided with the DRM-7000

The following components are included with the original shipment of the Pioneer DRM-7000
Changer.
• 20-Disc Hyper Magazine
A single 20-disc magazine (included at not cost with the purchase of a DRM-7000) may
be installed and removed without opening an access panel. The lock, located on the
exterior of the changer, is equipped with a memory system that records all user
operations
• SCSI Drive Cable (1)
cable compatible with the market standard
• Power Cord (1-US/Canada & 1/Japan)
excess power cord may be discarded
• Placement Fixtures (set)
Set includes 4 brackets
• Chassis Keys (2)
DRM-7000
- 5 -
Operating Instructions