Pioneer DRM-7000 Operating Instructions Manual page 23

Once the initialization is complete, the following message appears in the LCD display:
Robotics
Drive1
The first line of the message refers to the status of the disc changer mechanism. The second
line indicates the disc number and registers any loaded discs. Drive numbers are assigned in
sequence from the lowest to the highest number.
Note: If the number of drives registered exceeds the maximum number of drives allowed for
installation, open the rear access door and check the drive power cables and the interface
connections. See the section entitled, System Administration mode: Access Panel Submodes, for
additional information.
DRM-7000
ready
no disc
- 19 -
Operating Instructions