2.
Loosen the shipping screws
With the front access panel open, loosen the two screws located in the base
3.
Install the drive units
No tools are required to install a drive. While drives may be installed in any of the rear
bays (bay 1 through bay 8), the connector board shipped with the Changer is configured
for drives to be installed into bay 1 and bay 2.
4.
Connect the power cord from the Changer to the drive.
DRM-7000
• Screws are permanent to avoid
becoming lost but must be loosened
to operate the Changer
• Tighten these screws before moving
or transporting the Changer
• Closing the front and/or rear access
panels cause the Changer to return
to the initial default position thus
leave access panels open to
continue with the installation process
• Specify the SCSI IDs and set the
termination switches on the back of
the drives before installing the units
• Verify that the drives are mounted on
the guide rails
• Listen for the clicking sound as the
drive is pushed into the bay
• Push the drive in until the lock lever
on the drive shifts to the locked
position
• Verify that the wiring monitor
indicator on the rear of the drive
lights as
• Check that the termination indicator
is
green
ON
- 12 -
Operating Instructions
orange
if the Termination Switch is