Auto Probing - Pioneer DRM-7000 Operating Instructions Manual

The optional operations are as follows when scanning using the right arrow button:
• Auto Probing – default set to OFF at time of shipment
• Inquiry Change – default set to OFF at time of shipment
• Free Message – default set to Off at time of shipment
• Alert Buzzer – default set to ON at time of shipment
• Hyper I/E – default set to ON at time of shipment
• Auto Eject – default set to ON at time of shipment
• Hot Start – default set to OFF at time of shipment

5.2.3.1 Auto Probing

When standard 50-disc and hyper magazines have discs added while outside
of the DRM-7000, the system requires a slot check before accessing the new
discs. An Auto Probe command checks all magazine slots in sequence to
determine whether each slot is empty or full. The Controller software usually
performs this check. However, if the software fails to support this activity or the
Changer is disconnected from a host computer, use the Auto Probing function.
Commands from the host computer are ignored during an Auto Probe issued
through the controller program.
Even after switching Auto Probing from OFF to ON, the feature is unavailable
until an access door is opened then closed or until the unit is reset.
Auto probing?
Press the Enter button
A u t o p r o b i n g i s
set to ON / OFF
Press the left arrow button
A u t o p r o b i n g i s
set to ON / OFF
Press the Enter button
A u t o p r o b i n g
i s a c t i v a t e d
DRM-7000
- 25 -
Operating Instructions