DVD-ROM DRIVE UNIT DVD-D7361 Operating instructions English Section...
This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). Ce produit est conforme aux directives relatives à la compatibilité électromagnétique (89/336/CEE, 92/31/CEE) et à la directive CE relative aux marquages (93/68/CEE). Dieses Produkt entspricht den EMV-Richtlinien (89/336/EEC, 92/31/EEC) und CE- Markierungsrichtlinien (93/68/EEC).
WARNING: Thank you for buying this Pioneer product. TO PREVENT FIRE OR Please read through these operating SHOCK HAZARD, DO NOT EXPOSE THIS instructions so you will know how to APPLIANCE TO RAIN OR MOISTURE. operate your model properly. This product is an optional drive designed...
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
SAFETY INSTRUCTIONS To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow these safety precautions: ENVIRONMENT - Please use the unit at a place where it is not subjected to vibrations or shocks. READ INSTRUCTIONS - Read all safety and operating instructions before the Drive is operated.
FEATURES ÷ High-speed reading Transfer rate (sustained): maximum 8,100 kBytes/sec. (DVD-ROM) maximum 4,800 kBytes/sec. (CD-ROM) NOTE: The data transfer rate may not be output due to disc conditions (scratches, etc.). ÷ High-speed access (Random average): 120 ms (DVD-ROM) 90 ms (CD-ROM) ÷...
A HARDWARE TOUR 1 2 34 REAR VIEW BLOCK SIZE 512 byte 2048 byte WIRING MONITOR IND SCSI TERM IND BLOCK SIZE TERM ON / OFF RELEASE LOCK SCSI ID 1 SCSI termination switch been specified as the drive to be swapped during the swapping of drives.
A HARDWARE TOUR TOP VIEW 0 Function switch ON OFF ¶ Set ON at the time of shipping from the plant. This switch is used to check the ¶ For a DVD Video playback system (computer) device before shipment, and its setting should never be changed.
TO INSTALL THE DRIVE 1. When inserting a drive, be sure to 3. Connect the changer interface cable. ¶ When the changer interface cable has place the drive on the changer guide been connected, the wiring monitor rails and push the drive in until the indicators will flash at two-second lock lever on the drive shifts to the intervals.