Changing The Scsi Id On Adrm-7000; Reading Scsi Drive Ids From The Drm-7000 - Pioneer DRM-7000 Operating Instructions Manual

5. Connect the Changer Interface cable to the drive.
4.3 Changing the SCSI ID on a DRM-7000
To alter the Changer's SCSI ID, power the system OFF then press the SCSI ID switches
located on the back of the unit in the lower left area. Pressing the switches causes the ID to
change and the following message to appear on the LCD display.
In this example, the Changer's SCSI ID changes from SCSI ID 6 to SCSI ID 0.
Powering the system back ON resets the SCSI bus to the host computer. The new SCSI ID for
the DRM-7000 is maintained until the SCSI ID switches on the back of the unit are altered.
4.4

Reading SCSI Drive IDs from the DRM-7000

If all drives have been assigned separate SCSI IDs, a buzzer sounds once. If the same SCSI
ID has been assigned to two or more drives, the buzzer sounds three times. Installing multiple
(Inquiry) ID = 6 ( 0 )
Revision
- 13 -
DRM-7000
• Confirm that the interface cable is
connected to the correct bay
Caution: Connecting the interface cable to an
incorrect bay port results in damage to the discs.
• Install an add-on connector board if
necessary
*.***
Operating Instructions