Toshiba 55SL417U Owner's Manual page 6

1, Remove the four screws.
(Do not use these for attaching
a wall bracket,)
2. Place the four spacers (supplied).
Screw
Wall bracket
Spacer (supplied)
TV back panel
Removingthe Pedestal Stand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the
stand protruding over the edge of the surface.
Note: Extreme care should a/ways be used when
removing the pedestal stand to avoid damage to the
LCD pane/.
2) Remove the seven screws.
3) Once you have removed all
seven screws holding the
pedestal stand in place, remove
the pedestal stand from the TV
Seven screws
by sliding the pedestal stand
away from the TV.
USA - FederalCommunications
FCCComplianceStatement
Toshiba television models 42SL417U, 46SL417U, and
55SL417U comply with Part 15 of the FCC Rules.
Operation is subject to tile following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
The party responsible for compliance to these rules is:
Toshiba America Information Systems, Inc.
9740 Irvine Blvd., Irvine, CA 92618.
Ph: 1-800-631-3811
Interference: This equipment has been tested and found
to comply with the limits for a C/ass B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference wifl not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of
the following measures:
* Reorient or relocate the receiving antenna.
° Increase the separation between the equipment and
receiver.
° Colulect the equipment into an outlet on a circuit
different from that to which the receiver is COlUlected.
° Consult the dealer or an experienced radio/TV teclulician
for help.
Wireless Radio
For product available in the USA/Canada market, only
channel 1-11 can be operated. Selection of other channels is
not possible.
The device could automatically discontinue transmission
in case of absence of information to transmit, or operational
failure. Note that this is not intended to prohibit
tr_nlsmission of control or signaling information or the use
of repetitive codes where required by the teclulology.
If this device is going to be operated in 5.15-5.25GHz
frequency range, then it is restricted to an indoor
environment only.
Important: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or
transmitter.
FCC Radiation Exposure Statement: This equipment
compiles with FCC radiation exposure limits set forth for an
uncontre//ed environment. This equipment should be
instafled and operated with minimum distance 20 cm
between the radiator & your body.