Sony Handycam DCR-HC85 Operation Manual page 119

Symptom Cause and]or Corrective Actions
Cannot delete all pictures at once. .+When you are using the "Memory Stick Duo" with the write-protect tab
release the lock on tile write-protect tab of the "Memory Stick Duo."
(p. 128)
.+Cancel image protection on the picture. (p. 108)
Image protection cannot be applied. .+When you are using tile "Menlory Stick Duo" with the write-protect tab
release the lock on the write-protect tab of the "Memory Stick Duo."
(p. 128)
.+Perform tile operation again on the index screen (p. 108)
Cannot nmlk pictures tbr print .+When you are using tile "Memory Stick Duo" with the write-protect tab
release the lock on the write-protect tab of the "MemoW Stick Duo."
(p. 128)
.+Perform tile operation again on the index screen. (p. 109)
• The maximmn munber ofpictmes you can mark tbr print is 999
• Movies cannot be marked tbr print.
The data file name is not indicated • Only the file name is displayed if the directmT structure does not
CO1Tectly conform to the mlivelsal standard.
• The file is danmged.
• The file tblmat is not suppmted oil your camcorder (p. 127)
The data file name flashes. • The file is danmged.
• The file tblmat is not suppmted oil your camcorder (p. 127)
Symptom Cause and/or Corrective Actions
Pictures from connected devices me • Cannot change tile setting of tile AUDIO,'YIDEO jack during Easy
not displayed on the LCD screen o! Han@cam operation
the viewfinder. +Cancel Easy Handycam opeiation qJ. 54), and then set [VIDEO
INPUT] to the appropriate signal in the (STANDARD SET)
menu (p. 86)
.+Set [VIDEO INPUT] to the appropriate signal in tile (STANDARD
SET) menu. (p. 86)
'+Set [DISPLAY] to [LCD PANEL] in tile (STANDARD SET)
menu. (p 88)
Cannot dub correctly using tile _'\: "+Set [VIDEO INPUT] to the appropriate signal in tile _ (STANDARD
connecting cable SET) menu. (p. 86)
"+Set [DISPLAY] to [LCD PANEL] in tile (STANDARD SET)
nlenll. (p 88)
• The A/V co*meeting cable is not connected properly
"+Make sme that the A/V connecting cable is connected to the proper
jack, i.e. to the output jack of a device you a*e dubbing a pictme from,
or to the input jack of another device fo* dubbing a picalre fiom your
camcordei
• The input signal is not NTSC. (p 95)
Pictures flora connected devices are
not displayed correctly.
New smmd added to a recorded tape
is not heard
T
->In the (STANDARD SET) menu, adjust [AUDIO MIX] fiom tile
....... <,,, ,
[ST 1] (original sound) side until the sound is heard appropriately. (p. 85)
,-bcontinued
_3"
Troubleshooting 119