Sony Handycam DCR-HC85 Operation Manual page 114

Symptom Cause and/or Corrective Actions
The CHG (chalge) lamp does not -)'Attach the batte27 pack to the camcolde! conectly. It'the lamp still does
light while the batte25" pack is being not light up, then it indicates that no powe2 is supplied from the wall
charged outlet.
• The batte W charge is completed (p. 14)
The CHG (charge)lamp flashes while ÷Attach the batte27 pack to the camcorde! correctly. If the problem
the batte! 7 pack is being charged, persists, discoimect the AC Adaptor flom the wall outlet and contact
your Sony dealer Tile battel), pack may be damaged. (p 14)
The batte*y pack is quickly • The tempelamre of the environment is too low, or the batte2), pack has
discharged, not been charged enough This is not a malfimction.
+Fully charge the batte! 7 again If the problem persists, replace the
batte2), pack with a new one It may be damaged. (p. 14, 130)
The remaining batte2_" time indicator • The tempemtme of the environment is too high or too low, or the batte W
does not indicate the correct time. pack has not been charged enough. This is not a malfimcfion.
+Fttlly charge tile batte! 7 again If the problem persists, replace the
batte2), pack with a new one It may be damaged (p. 14, 130)
The powe! lm-ns off frequently • A problem has occtmed in the remaining batte27 time indicator, or the
although the remaining batte W batte27 pack has not been charged enough.
indicator indicates that the battery -)Fully charge the batte! 7 again to conect tile indication. (p 14)
,ack has enough power to operate.
The powe! abruptly turns oft'. • [A.SHUT OFF] in the (STANDARD SET) menu is set to [5min]
(p s8)
">When approximately 5 nlinlltes have elapsed while yoll do not operate
your camcorder, the camcorder is automalically lxmled off.
Slide the POWER switch down to turn the powe2 on again (p. 17). Or
use the AC Adaptor.
A problem occms when the + Turn off the power, and disconnect the AC Adaptor flora the wall outlet.
camcorder is connected to the AC Then, connect it again.
Adaptor
Symptom Cause and/or Corrective Actions
Cassette cannot be ejected flom the -'>Make sme the power source (batte W pack 02 AC Adaptor) is connected
compmtment correctly. (p. 14)
Remove the battel), pack from the camcorder, then attach it again. (p 14)
÷Attach a charged battery pack to the camcorder (p 14)
Cassette is not ejected even when the • Moisture condensaflon is starting in your camco2der (p. 133)
cassette lid is open.
114 Troubleshooting