SOLE E55 Owner's Manual page 11

STEP 2: Handlebar Assembly
1. Install the two 25m/m Wave Washers (175) onto the Left and Right side of the Handle Bar axle.
2. Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The
handlebars have a small sticker on them indicating L (left) and R (right).
3. Install two 3/8 X 30mm Flat Washers (165) onto the two 3/8" X 3/4" Hex Head Bolts (132) and
install, and tighten, in the threaded holes in the ends of the axle.
4. Connect the two wires (Left-61 to 63 & Right-60 to 62) on the L&R sides together and store the
excess wire, including plastic connectors, back inside the console mast. Place the rubber
grommets (75) over the wire and snap it into the hole in the console mast. Install the Front
Handle Bar Covers (105 left, 107 right) and Rear Handle Bar Covers (106 left, 108 right) over
the Handle Bar axle connections and secure with the eight 3.5xl0m/m Sheet Metal Screws
(142).
/
/
I/ /
142 106 // ,/
59
107
/
165
1,52
11 ', 'i
]t
i i
J i
J i
10 E55 / E95 Elliptical