Table of Contents
Advertisement
"IV CHANNEL
SELECT{ON
PRESETTING
YOUR CATV
SYSTEM
(When
the cable
box output
is connected
to the ANTENNA
terminal
on the rear panel.)
Press the INPUT SELECTOR
button so that "TV CHXX" appears on the
monitor screen, or press the "IV input selector key on the remote con-
trol unit.
_*
Turn on the menu with the MENU ON/OFF button and press the MENU
SELECT/ADJUST
buttons so that the W-CAW
MODE display turns
red.
_3
Press the MENU SET button.
Each press the MENU button,
"AIR",
"STD" or "HRC" appears on the screen.
=4_ Select "STD (standard)"
or "HRC" with the MENU SET button. (Ask your
dealer or cable service provider which is correct for your local CATV sys-
tem.) Each press O_the MENU SET button moves the seLectien from AIR to
STD, to HRC, and then bask to AIR again,
The displayed
mode ("STD" or "HRC")
is now preset in the ANTENNA
memory, so you can receive your local CATV broadcast
when the TV is
turnedon,
Press the MENU
ONIOFF
button to returnto normal operation.
CABLE (CA'FV) CHANNEL
SELECTION
It is necessary
to preset your local CATV system in ANTENNA
memory. To
preset your CA'iV system, see "PRESETI'ING
YOUR CAW SYSTEM",
Press the INPUT SELECTOR button so that "TV CHXX" appears on the
monitor screen, or press the "IV input selector key on the remote con-
trol unit.
Select channels directly by pressing the channel number on the remote
control 10-key pad. For example, to receive channel "23", press the 2 and
then 3. For channeJs 1 through 9, first press 0 (zero). then the number: or
just press the number and wait for about four seconds. Note that channel
numbers
"00", and "66" through "93" are not assigned, so the selected
channel will not change if you input these numbers.
You can select VHF channels (1--13),
mid-band channels (A1--A6, A--I),
super-band
channels (J--W),
and hyper-band
channels (AA--CCC).
Ref*
er to the standard cable channel assignment table shown on page 22. Your
local cable service provider's
channel assignments
may differ from those
shown in the table,
I_
Channel memory
selection is also possible. Using the CHANNEL
keys
marked "+" and "--" on the remote control unit or the CHANNEL
butlons
marked "+" and "-"
on the control panel you can scan through the chan-
nels in channel
memory.
To add or delete channels from memory,
see
TUNER PRESET on page 32.
MENU ON/OFF
button
i
_=RE_E
T rvle- r,jL j
MENU SELECT/
ADJUST buttons
MENU SET button
TV Input selector key
_m_iJEC_I_
MIDNpTOm
P_CEI',,-1Em
10-key pad
TV CHANNEL
key
28
Advertisement
Table of Contents
