Table of Contents
Advertisement
Overlay
An overlay sheet is provided, on which you can write the func-
tions of keys you have programmed from other remote control units
It fits over the unit keyboard for your own personal reference
Questions
and Answers
on Programming
Commands
Q: The remote control unit for my VCR has two REC keys, which
both have to be programmed
at the same time to start recor-
ding. How should I program this into my programmable remote
control unit?
A: PreSs and hold both REC keys on the programmable
remote
control untilthe TRANSMIT/LEARN indicator fightsup, and then
press the two keys on the VCR remote control simultaneously,
Q: The remote control unit of my VCR has a REC key and a PLAY
key, and they both have to be _essed
at the same time to start
recording. How should I program this into my programmable
remote control unit?
A: PreSs and hold both REC keys on the programmable
remote
control until the TRANSMIT/LEARN indicator lights up, and then
press the REC and PLAY keys on the VCR remote control
simultaneously.
NOTE:
ff both keys are not pressed simultaneously in the above mention-
ed operahons, the commands will not be memorized.
Battery Replacement
RepLace the batteries as soon as possible if pressing the Control
keys does r..o{cause the TRANSM_TILEARN ir,_cator to _ight even
after the RESET button has been pressed.
Be sure to always use the specified batteries (LR6/AM3 alkaline
batteries).
NOTE:
The unit's power switch is COnnected to the battery compartment
cover. Therefore:
oThe unit will not operate when the cover is off even d batteries
are loaded.
off the cover Jsreplaced when baltenes are not loaded the memory
will be lost after e few Seconds.
oWith batteries loaded and the cover Off, memory is retained for
about
15 minutes.
QBe very careful not to lose the battery compartment
cever
Returning
to the Initial Settings
Follow
the instructions
below
to return
all settings
to the
PIONEER Remote Control Code Settings.
(_
Set the LEARN MODE selector to the LEARN position
(_)
Press any programmable
key (The TRANSM!T/LEARN
_n-
dicafor will light.)
(_
Using a ball.point pen or similar object, press and hold lhe
M.CLR button down untillthe indicator flashes and then goes
out.
All commands
you programmeO will be erased, and the unit wil!
be reset to use codes initially set by PIONEER
22
[
Mr
\
"__
Advertisement
Table of Contents
