Speakers - Pioneer SD-P4053 Operating Instructions Manual

SPEAKERS
CONNECTING E_ERNAL SPEAKER WIRES
_L
10 mm (1/2 in) Insert ._
Release
Press
Strip each wire so
that about half an
inch is exposed.
Twist the core.
Turn off the power of the monitor and
connected equipment.
Press the {ever, insert the wire, and re*
{ease the lever to lock the wire into
place. Pull gently on the wire to check
that it is securely connected
Do this for each wire. Be careful to connect the right speaker's plus
and minus terminal wires to the "R" "+" and "--" terminals. Like-
w_se, connect the left speaker's I_US and minus terrninal wires to
the "L" "+" and "--" terminals.
Precautions
oMake sure that exposed wires do not protrude end touch
each other.
elf you do not hear a normal stereo image when listening to
a stereo program, it may be because the "+" and "--" con-
nections are reversed for one of the external speakers.
eMake sure that the right speaker is connected to the "R"
terminals and the left speaker to the "L" teminals. Make
sure that each speaker's two wires are properly connected
to the appropriate "+" and "--" terminals.
NOTES:
eUse speakers with an impedance rating ranging from 8
ohms to 16 ohms.
OOrdinary speakers are not magnetically shielded and may
disturb the picture ff placed too close to the monitor. If you
notice a problem, move the speakers about 2 feet (60 cm)
away from the monitor.
SPEAKER SELECTOR SWITCH
Set this switch to the INT position if you will be listening to the
built-in speakers, If you have connected external speakers
(or if you will be listening through your stereo system), then
you can turn off the built-in speakers by setting the selector
to the EXT position.
EXT INT
/
/ / /
,/
I_o_jj
I
J
j/
13