Install The Pilot Burners; Support Bracket Installation; Angle Tie Brace Installation - PEERLESS SERIES 211A Installation, Operation & Maintenance Manual

3. Attach the Front Panel and Back Panel (Figure 9) to the
Left Hand End Panel using 5/16" -18 x 1" cap screws
and hex head nuts provided.
4. For 211A-04 through 211A-08 Only:
a) Complete the base assembly by attaching the Right
End Panel and setting the Burner Support Channel
on the clips.
_ Front
Jacket •
Panel
Figure 11: Support Bracket Installation
5,
6,
7.
8,
9.
For 211 A-09 through 211 A-46 Only:
a) Attach a Front Panel Support Bracket to each Front
Panel as shown in Figure 11.
Attach an Angle Tie Brace at each panel joint to secure
the front and back panels as shown in Figure i0 using
5/16"48 x 1" cap screws and hex head nuts.
Bolt remaining Front and Back Panels together using
5/16"-18 x I" cap screws and hex head nuts. See Table
2 for panels required. Place the panels in the positions
shown in the table and Figure 8.
Complete the base assembly by attaching the Right Hand
End Panel using 5/16"-18 x i" cap screws and hex head
nuts.
Set the Burner Support Channels in place as shown in
Figure 8.
I,
,
3.
Check the location of the Burner Support Channels in
the Base Assembly. The dimensions should be:
a) Height above boiler foundation: 63/4"
b) Distance from back of Base: 33/4"
Remove the Gas Manifold and Pilot Line Assembly from
Box Number 7.
Place Manifold on front of Base. Bolt the hangers using
5/16"-18 x 1" long cap screws with 5/16" fiat washers.
See Figure 12.
Front Panel
Angle Tie Brace
3 3/4"
T
6 3/4"
Figure 10: Angle Tie Brace Installation
8