Fisher & Paykel RX256DT7X1 Installation Instructions And User Manual page 33

T
ROUBLESHOOTING
Ice and Water
PROBLEM
POSSIBLE CAUSES
No indicator lights Freezer door is not closed.
are lit on dispenser
control
Refrigerator is not plugged in.
Fuse is blown, or circuit breaker
needs to be reset.
Power outage has occurred.
Refrigerator is in Sabbath Mode
(select models).
Freezer door is not closed.
Ice or water are
not dispensed
Controls are in lock mode (select models).
when pads are
Water tank is filling.
pressed
Ice bin not installed properly.
Ice maker has just been installed or
a large amount of ice has been used.
Water pressure is to low.
Water filter is clogged or needs to
be changed.
Ice maker has just been installed or
Ice maker is not
a large amount of ice has been used.
producing enough
Water pressure is too low.
ice or ice is
malformed
Water filter is clogged or needs
to be changed.
Water pressure is too low.
Ice forms in inlet
tube to ice maker
Saddle valve not open completely.
Freezer temperature is too high.
Plastic tubing was used to complete
Refrigerator is
water connection.
leaking water
Improper water valve was installed.
WHAT TO DO
Verify that freezer door is closed. Power is removed
from the control when freezer door is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped circuits.
Call local power company listing to report outage.
See Sabbath Mode, page 9.
Verify that freezer door is closed. Power is removed
from the control when freezer door is opened.
See Dispenser LOCK, page 16.
At initial use, there is an approximate one- to two-
minute delay in dispensing while the internal water
tank is filling.
Reinstall ice bin, see page 14.
Wait 24 hours for ice production to begin or for ice
maker to restock after emptied.
Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Change water filter (see page 17).
Wait 24 hours for ice production to begin or for ice
maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Change water filter (see page 17).
Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Open saddle valve completely.
See Temperature Controls, page 8. Freezer
temperature should be between 0° to 2° F
(-18° to -17° C).
The manufacturer recommends using copper tubing
for installation. Plastic is less durable and can cause
leakage. The manufac turer is not responsible for
property damage due to improper installation or
water connection.
See Connecting the Water Supply, pages 6 and 7.
Self-piercing and " saddle valves cause low water
3
⁄
16
pressure and may clog the line over time. The
manufacturer is not responsible for property
damage due to improper installation or water
connection.
Cont.
30